Table of Contents
Advertisement
272
IN CASE OF EMERGENCY
SPARE TIRE REMOVAL
1. To remove the spare tire from the carrier, remove
the tire cover, if equipped.
2. Remove the Rear Camera Cover by turning the lock
bolt counterclockwise with the #T40 torx head driver
and ratchet from the supplied tool kit.
Unlock Rear Camera Cover
3. Remove the lug nuts with the lug wrench turning
them counterclockwise. If equipped, remove the
locking lug nut with the lock key (located in the glove
box) turning it counterclockwise.
Removing The Spare Tire
JACKING INSTRUCTIONS
WARNING!
Carefully follow these tire changing warnings to help
prevent personal injury or damage to your vehicle:
•
Always park on a firm, level surface as far from the
edge of the roadway as possible before raising the
vehicle.
•
Turn on the Hazard Warning Flashers.
•
Apply the parking brake firmly and shift an auto-
matic transmission into PARK; a manual transmis-
sion into REVERSE.
•
Block the wheel diagonally opposite the wheel to
be raised.
•
Never start or run the engine with the vehicle on a
jack.
•
Do not let anyone sit in the vehicle when it is on a
jack.
•
Do not get under the vehicle when it is on a jack. If
you need to get under a raised vehicle, take it to a
service center where it can be raised on a lift.
•
Only use the jack in the positions indicated and for
lifting this vehicle during a tire change.
•
If working on or near a roadway, be extremely care-
ful of motor traffic.
•
To assure that spare tires, flat or inflated, are
securely stowed, spares must be stowed with the
valve stem facing the ground.
Jack Warning Label
1. Remove the spare tire, jack and tools from the
stored location.
2. Loosen (but do not remove) the wheel lug nuts by
turning them to the left one turn while the wheel is
still on the ground.
3. Assemble the jack and jacking tools. Connect the
jack handle driver to the extension, then to the lug
wrench.
Assembled Jack And Tools
Advertisement
Table of Contents
