Jeep WRANGLER 2024 Owner's Manual page 50

48 GETTING TO KNOW YOUR VEHICLE
Door Removal Warning Label
WARNING!
•
All occupants must wear seat belts during off-road
operation with doors removed. For off-road driving
tips, see page 195.
•
Do not store detached doors inside of the vehicle,
as they may fly around and cause personal injury
or death in the event of a sudden stop, rough ter-
rain, or a collision.
NOTE:
•
Doors are heavy; use caution when removing them.
•
Hinge pin can break if overtightened during door
reinstall (Max Torque: 7.5 ft· lb / 10 N·m). For off-
road driving tips, see page 195.
To remove the rear doors, proceed as follows:
1. Roll down the glass window to prevent any damage.
2. Remove the hinge pin screws from the upper and
lower outside hinges (using a #T50 Torx head driver).
NOTE:
The hinge pin screws and nuts can be stowed in the
rear cargo tray located under the rear load floor.
Hinge Pin Scre5
3. Slide the front seat(s) fully forward.
4. Pry open and remove the plastic wiring access door
from the bottom of the B-pillar.
Wiring Access Door
5. Unplug the wiring connector.
NOTE:
Squeeze the tab on the base of the wiring harness.
This will unlock the connector tab, allowing the wir-
ing connector to be unplugged.
Wiring Connector
6. With the door in the open position, remove the
check screw from the door check attachment on the
body (using a #T40 Torx head driver).
NOTE:
Keep the check arm in the extended position for
easier reinstallation.