Rear Seat Armrest - If Equipped; Unfolding The Rear Armrest - Phev Only; Heated Seats - If Equipped - Jeep WRANGLER 2024 Owner's Manual

Table of Contents

Advertisement

62
GETTING TO KNOW YOUR VEHICLE
Removing The Rear Seat
1. Push down on the release bar on each side, and pull
the seat out and away from the lower bracket.
Release Bar Location
2. Remove the seat from the vehicle.
3. To reinstall the rear seat, just reverse these steps.
NOTE:
Do not drive the vehicle without reattaching the rear
seat latches.
WARNING!
It is extremely dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seriously
injured or killed.
Do not allow people to ride in any area of your vehicle
that is not equipped with seats and seat belts.
Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
In a collision, you or others in your vehicle could be
injured if seats are not properly latched to their floor
attachments. Always be sure that the seats are fully
latched.
REAR SEAT ARMREST —
IF EQUIPPED
The center part of the rear seat can also be used as a
rear armrest with cupholders. To unfold it, grab the pull
strap under the head restraint and pull it forward.
NOTE:
The cupholder liner can be removed for cleaning.
Be certain that the seatback is securely locked into
position. If the seatback is not securely locked into
position the seat will not provide the proper stability
for child seats and/or passengers. An improperly
latched seat could cause serious injury.
(Continued)
WARNING!
Rear Seat Armrest
WARNING!
UNFOLDING THE REAR ARMREST —
PHEV ONLY
Raise the rear center head restraint, then pull the rear
armrest tab to release it from the seat and pull forward.
Pull the rear armrest tab to release it from the seat and
pull forward.
Armrest Tab Location
The center part of the rear seat can also be used as a
rear armrest with cupholders.
HEATED SEATS — IF EQUIPPED
The heated seat control buttons are located
on the center instrument panel below the
touchscreen and also in the Climate Control
touchscreen menu.
Press the heated seat button once to turn the HI
setting on.
Press the heated seat button a second time to turn
the MED setting on.

Advertisement

Table of Contents
loading

Table of Contents