Table of Contents
Advertisement
204
MULTIMEDIA
Display Brightness Daytime
Theme Mode
Set Theme
Units
Touchscreen Beep
Show Main Category Bar Labels
Time Format
Voice Options
Wake Up Word
Voice Barge-in
Show Command List
Navigation Settings
Auto-On Driver Heated/Ventilated Seat & Heated Steering Wheel
Radio Off Delay
Setting Name
This setting will allow you to adjust the "Brightness Daytime" setting. Selectable
options are 1 through 10.
This setting will allow you to adjust the brightness of your theme. Setting options are
"Light", "Dark" and "Auto". Select to show Themes in Light or Dark mode. "Auto"
changes the theme with the headlights.
This setting will allow you to change the display theme.
This setting will allow you to customize the units for "Speed" (mph or km/h), "Dis-
tance" (mi or km), "Fuel Consumption" (MPG [US], MPG [UK], L/100 km, or km/L),
"Pressure" (psi, kPa, or bar), "Temperature" (°C or °F), and "Torque" (Nm or lb-ft) units
of measurement independently.
This setting will allow you to turn the touchscreen beep on or off.
This setting will allow the main category bar labels to be shown on or off.
This setting will allow you to set the time format (AM/PM). Sync Time With GPS must
be "Off" for this setting to be available. The "12 hrs" setting will set the time to a
12-hour format. The "24 hrs" setting will set the time to a 24-hour format.
This setting will allow you to change the voice options for the radio to "Male" or
"Female".
This setting will allow you to set the system "Wake Up" word. The available options are
"Off", "Hey, Uconnect", and "Hey, Jeep".
This setting will allow Voice Barge-in to be turned on or off.
This setting will allow the Command List to be shown on or off.
This setting will redirect to the list of Navigation settings. Refer to your Uconnect Radio
Instruction Manual for further information.
This setting will activate the vehicle's comfort system and heated seats or heated
steering wheel when the vehicle is remote started or ignition is started. The "Off" set-
ting will not activate the comfort systems. The "Remote Start" setting will only activate
the comfort systems when using Remote Start. The "All Start" setting will activate the
comfort systems whenever the vehicle is started.
This setting will keep certain electrical features running after the engine is turned off.
When any door is opened, the electronics will deactivate. The available settings are
"0 min" and "20 min".
Description
Advertisement
Table of Contents
