Table of Contents
Advertisement
2WD High Indicator Light — If Equipped
With a Premium Instrument Cluster
This light alerts the driver that the vehicle is
in the Two-Wheel Drive High mode.
Hill Descent Control (HDC) Indicator
Light — If Equipped
This indicator shows when the HDC feature
is turned on. The light will be on solid when
HDC is armed. HDC can only be armed when
the transfer case is in the 4WD Low position
and the vehicle speed is less than 30 mph (48 km/h). If
these conditions are not met while attempting to use
the HDC feature, the HDC indicator light will flash
on/off.
Max Regeneration Indicator Light —
PHEV Only
This indicator light will illuminate to indicate
that Max Regeneration is on and not ready.
When the switch is pressed, the following
instrument cluster messages will be seen:
•
"Max Regeneration On" – appears when the feature
is turned on.
•
"Max Regeneration Off" – appears when the feature
is turned off.
•
"Max Regeneration Unavailable" – appears when
the feature is requested, but the vehicle is unable to
comply. LED will flash for five seconds to indicate
unavailability
page 19.
Selec-Speed Control Indicator Light —
If Equipped
This light will turn on when "Selec-Speed
Control" is activated.
To activate "Selec-Speed Control", ensure
the vehicle is in 4WD Low and push the but-
ton on the Instrument Panel.
NOTE:
If the vehicle is not in 4WD Low, "To Enter Selec-Speed
Shift to 4WD Low" will appear in the instrument cluster
display.
Cruise Control Ready Indicator Light —
If Equipped With A Premium Instrument
Cluster
This light will turn on when the Cruise Con-
trol has been turned on, but not set.
Cruise Control SET Indicator Light —
If Equipped With Base Instrument
Cluster
This indicator light will illuminate when the
Cruise Control is set.
GETTING TO KNOW YOUR INSTRUMENT PANEL
BLUE INDICATOR LIGHTS
High Beam Indicator Light
This indicator light will illuminate to indicate
that the high beam headlights are on. With
the low beams activated, push the multifunc-
tion lever forward (toward the front of the
vehicle) to turn on the high beams. Pull the multifunc-
tion lever rearward (toward the rear of the vehicle) to
turn off the high beams. If the high beams are off, pull
the lever toward you for a temporary high beam on,
"flash to pass" scenario.
GRAY INDICATOR LIGHTS
Cruise Control Ready Indicator Light —
If Equipped With Base Instrument Cluster
This light will turn on when the Cruise Con-
trol has been turned on, but not set.
ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated Onboard
Diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and trans-
mission control systems. When these systems are oper-
ating properly, your vehicle will provide excellent perfor-
mance and fuel economy, as well as engine emissions
well within current government regulations.
If any of these systems require service, the OBD II sys-
tem will turn on the Malfunction Indicator Light (MIL).
It will also store diagnostic codes and other information
to assist your service technician in making repairs.
141
3
Advertisement
Table of Contents
