Table of Contents
Advertisement
WARNING!
•
Never add fuel when the engine is running. This is
in violation of most state and federal fire regula-
tions and may cause the "Malfunction Indicator
Light" to turn on.
•
A fire may result if fuel is pumped into a portable
container that is inside of a vehicle. You could be
burned. Always place fuel containers on the
ground while filling.
CAUTION!
To avoid fuel spillage and overfilling, do not "top off"
the fuel tank after filling.
Emergency Fuel Door Release
1. Place the vehicle's ignition in the RUN position (Pro-
pulsion System Active (PSA) not active).
NOTE:
If this is not performed, then the tank vent valve will
not open. This will result in premature fuel pump
shutoffs.
2. Access the rear quarter trim panel in the cargo area
on the left side of the vehicle.
Release Cap Location
3. Remove the release cap from the quarter trim
panel.
4. After removing the release cap, pull it directly away
from the quarter trim panel to release the fuel door.
Fuel Door Emergency Release
5. Reinstall the release cap into the quarter trim when
completed.
6. Wait 15 seconds and then begin fueling your
vehicle.
STARTING AND OPERATING
LOOSE FUEL FILLER CAP MESSAGE
After fuel has been added, the vehicle diagnostic sys-
tem can determine if the fuel filler cap is possibly loose,
improperly installed, or damaged. If the system detects
a malfunction, the "gASCAP" message will display in the
odometer display. Tighten the gas cap until a "clicking"
sound is heard. This is an indication that the gas cap is
properly tightened. Push the odometer reset button to
turn the message off. If the problem persists, the mes-
sage will appear the next time the vehicle is started.
This might indicate a damaged cap. If the problem is
detected twice in a row, the system will turn on the MIL.
Resolving the problem will turn the MIL off.
VEHICLE LOADING
CERTIFICATION LABEL
As required by National Highway Traffic Safety Adminis-
tration regulations, your vehicle has a certification label
affixed to the driver's side door or pillar.
This label contains the month and year of manufacture,
Gross Vehicle Weight Rating (GVWR), Gross Axle Weight
Rating (GAWR) front and rear, and Vehicle Identification
Number (VIN). A Month-Day-Hour (MDH) number is
included on this label and indicates the Month, Day and
Hour of manufacture. The bar code that appears on the
bottom of the label is your VIN.
Gross Vehicle Weight Rating (GVWR)
The GVWR is the total permissible weight of your vehicle
including driver, passengers, vehicle, options and cargo.
The label also specifies maximum capacities of front
and rear axle systems (GAWR). Total load must be lim-
ited so GVWR and front and rear GAWR are not
exceeded.
187
4
Advertisement
Table of Contents
