Table of Contents
Advertisement
52
GETTING TO KNOW YOUR VEHICLE
5. Connect the wiring harness on the lower half-door to
the connection just inside the vehicle.
NOTE:
For front doors, make sure the wiring harness is
closed completely.
Front Door Wiring Harness
1 — Open Wiring Harness
2 — Closed Wiring Harness
6. Replace wiring access doors.
7. When the half-doors are shipped with the vehicle,
the lower half-doors will have plugs in the post holes
that must be removed prior to upper half-door instal-
lation. To remove these plugs, proceed as follows:
a. Locate the service hole in the center of each
plug of the lower half-door (two on each front and
rear door).
b. Place a tool (hook tool or trim stick is recom-
mended) in the service hole.
Place Tool Into Service Hole Of Plug To Remove
c. Using the tool, slowly pull upwards from the cen-
ter of the plug to remove.
8. Making sure the window on the upper half-door is
completely zipped closed, insert the upper half-door
into the lower half-door by placing the posts into the
post holes.
Lower The Upper Half-Door Into Post Holes
9. Push down firmly on the inside of the upper half-
door until it is fully seated in the lower half.
Push Down To Fully Seat Upper Half-Door
Door Latch Alignment
CAUTION!
Upon first installation of the half-doors, slowly set the
door almost to the closing position and check how
the door latch aligns with the body striker. Touch con-
dition between these components can result in dam-
age to both the door and the striker.
Check Door Latch And Striker Alignment
Advertisement
Table of Contents
