Table of Contents
Advertisement
4. The partition can be named by clicking on Label column and enter the name.
5. To create more than one partition, do the steps 2 and 4 again.
6. When all the partition has been added, click Start to format all partitions.
7. When the formatting complete, the each partition status will change to OK.
8. Click OK to exit when formatting is completed.
9. Now, user can assign formatted hard disk or partition as a storage path ( see also
setting)
Network Setting
Configure the network setting (IP address, subnet, DNS, gateway) of the system.
Enable DHCP: To use DHCP server assigning DVR server an IP address.
Static IP: Assign a fixed IP address for DVR server
-
IP ADDRESS: Assign a constant IP address which a real IP addresses give from ISP to
DVR system.
Do Not assign the DVR to 1.0.0.0 network segment. It will cause the DVR cannot access to
i
Internet due to the un-recognize to 1.0.0.0 IP segment.
-
Mask: It is a bitmask used to identify the sub network and how many bits provide room for host
addresses. Enter the subnet mask of the IP address which user has assigned to DVR system.
-
GATEWAY: A network device act as a passageway to internet. Enter the network gateway IP
address
-
DNS: Domain Name Server translates domain names (such as www.abb.com.tw) to IP
addresses. Enter the IP address of DNS if it is available.
Map Network Drive: To add network storage, the Internet storage drive/folder must be mapped as
Network Driver in DVR server. Follow the below steps to map the network drive.
1.
Click Map Network Drive button. In the Map Network Drive windows, select the Drive and fill
in the IP address and file folder of file server or NAS on your network in Folder.
2.
And then, click Finish to make the connection.
40
Chapter 4.1 System
Advertisement
Table of Contents
