Speco DVRPC16T2TB User Manual page 169

6. In (5) Alarm Reset, click the camera number (use  and  to select the alarm) to set the reset condition
of alarm. Once alarm is reset, all alarm action will stop at the moment. If the sensor normal status is high,
set the sensor condition to low.
- Alarm Reset Time: Set a time for the alarm auto reset. When an alarm happen such as motion
detected and video loss, the alarm will reset at the alarm reset time.
7. In (6) Action, you may now set the alarm action for the system to perform when the alarm condition is
activated.
- Launch E-Map
Display mini Emap screen.
- TV Out:
Switch to only display the video on TV from where the alarm is activated.

Retrieve time: set the waiting duration before system switching back to original display mode on
TV automatically. If the retrieve time is un-mark, the alarm video will keep displaying until user
switch back to normal display mode manually.
- Enlarge Camera View
Switch to only display video in Preview/Advanced mode from where the alarm is activated.

Retrieve time: set the waiting duration before system switching back to original Preview mode. If
the retrieve time is un-mark, the alarm video will keep enlarging until user switch back to Preview
mode manually.
- Send E-mail
Send an electronic text message. To setup click Detail (see also
- File Transmission via FTP
Upload file to remote computer thru FTP (File Transfer Protocol). To setup click Detail (see also
To Setup Send
163
E-mail).
To