Table of Contents
Advertisement
To Setup FTP Setting
1.
Next to the File Transmission via FTP check box, click
Detail.
2.
In the FTP Setting dialog box, enter the FTP IP, port,
user ID and password.
3.
In Number of Pic text box, enter the number of
sequence images that want to send when file is
transmitting. The maximum number of picture can be
transmitted are 16.
4.
Upload image when sensor is triggered: Select the
camera that the images will be captured and send
when the any alarm is triggered. If user select the
Alarm Camera, then only when motion trigger, video
loss, missing or suspicious object/scene change will
send out the alarm image.
5.
Click OK to exit and save the setting and Cancel to
exit without saving the setting.
To Setup Alarm Recording Setting
1.
Next to the Start Recording check box, click Detail.
2.
In the Alarm Recording Setting dialog box, select the
camera to enable/disable video recording. Enable All
to select all cameras.
3.
In the Frame Rate selection, select As Setting to
record the number of frames based on the Recording
Setting or Max to record the maximum of frames
based on the available speed.
4.
In the Stop Recording after text box, set the number
in second for the program to continue recording after
the alarm has ended.
5.
Click OK to accept the new settings and Cancel to exit
without saving.
To Setup Alarm SOP
Next to the Alarm SOP check box, click Detail. In the step text
boxes, type the standard protocol when the alarm is activated.
When the alarm is activated, the Standard Operation Procedure
dialog box will appear. Just click Next to see the next instruction,
Back to see the previous instruction, Finish to end and Abort
to terminate.
To Setup CMS Setting
Next to the Send to CMS check box, click Detail. In the CMS
Setting, select the camera to enable/disable sending the video
to CMS. Enable All to select all cameras. Then, click OK to
accept the new settings and Cancel to exit without saving.
165
Advertisement
Table of Contents
