Fuel Conversion - Jøtul GF 520 DV Installation And Operation Instruction Manual

130139 Rev 1 GF 520 DV 12/22

7. Fuel Conversion

The GF 520 DV gas stove is shipped from the factory equipped
to burn NATURAL GAS only. If PROPANE gas is to be used as
fuel, the appliance must first be converted by using the Propane
Conversion Kit 158331 included with the stove. Use Natural Gas
Conversion Kit 158332 to revert back to Natural gas.
THE CONVERSION KIT IS TO BE
INSTALLED BY AN AUTHORIZED SERVICE
TECHNICIAN IN ACCORDANCE WITH THE
MANUFACTURER'S INSTRUCTION AND
ALL CODES AND REQUIREMENTS OF
THE AUTHORITY HAVING JURISDICTION.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE. THE QUALIFIED
AGENCY PERFORMING THIS WORK
ASSUMES RESPONSIBILITY FOR THIS
CONVERSION.
THE CONVERSION SHALL BE CARRIED
OUT IN ACCORDANCE WITH THE
REQUIREMENTS OF THE PROVINCIAL
AUTHORITIES HAVING JURISDICTION
AND IN ACCORDANCE WITH THE
REQUIREMENTS OF THE CAN1-B149.1 AND .2
INSTALLATION CODE.
Tools required:
• 1/2" or 13 mm wrench or deep-well socket,
• Torx T20 screw driver
Conversion Kit Contents:
• 1, regulator tower labeled LP
• 2 regulator tower Torx Screws
• LP orifice: #52
• 1, Pilot Injector - BL .020 for NG - 226758
• Label A - to be completed and applied to
the lower door hinge.
• Label B - apply to the stove's Rating Plate
• Small valve label - apply to valve body
• Instructions
16
WARNING:
IN CANADA:
.013 for LPG - 226759
Fuel Conversion Procedure
1. Turn off gas supply to stove.
2. Remove top and front cast. Release the glass frame latches
to remove the glass frame and open the firebox. Tilt the glass
frame forward and lift it out of the stove. See initial assembly
page 5.
3. Open the Controls Compartment under the firebox. If
opening the Controls Compartment for the first time, loosen
the Air Shutter wing nut located below the firebox floor and
rotate the handle 180°. Push the Air Shutter handle as far
back as it will travel. See fig. 7.1.
4. Lift out Rear Burner Skirt.
5. Remove the Burner: Lift the front of the burner base to
disengage it from the support brackets and pull it forward off
of the burner injector. Then tilt it side-to-side and pull it out
through the firebox opening. Fig. 7.2.
5. Change the Burner Injector.
See fig. 7.3. Using a 1/2" open end wrench or deep-well
socket, remove the burner injector from the orifice holder and
replace it with the injector supplied in the conversion kit.
CAUTION: DO NOT OVER TIGHTEN!
Figure 7.1.
Rotate the Air Shutter Handle 180° and push Air Shutter FULLY
back to disengage burner from injector.
Figure 7.2. Remove Burner.