Table of Contents
Advertisement
Optional Wall Thermostat 750003
Use only a 750 millivolt DC two-wire circuit wall thermostat
with this appliance. The thermostat should be placed in the
same room as the heater, typically 5 feet off the floor. Avoid
drafty areas or any area that may affect the accuracy of the
thermostat.
The thermostat should be connected to the terminal block
using a minimum of 16 gauge wire with a maximum length of
25 feet of wire.
Connect either of the two thermostat wire leads to either
of two terminals on the terminal block located to the right of
the main gas valve. Do not overtighten the connections. IT
IS NOT NECESSARY TO DISCONNECT ANY OTHER
WIRES. See Fig. 10.7.
For thermostatic operation, the On/Off/T-Stat switch on
the back of the stove must be in the T-stat position, and the
pilot light must be running, as it is the power source for the
thermostat.
At the thermostat, the two wires should be connected to
the two connection screws on the thermostat base plate per the
manufacturer's instructions.
CAUTION:
LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN
SERVICING THE CONTROLS. WIRING ERRORS CAN
CAUSE IMPROPER OR DANGEROUS OPERATION. AL-
WAYS VERIFY PROPER OPERATION AFTER SERVICING
THE APPLIANCE.
THERMOPILE
TH
TP
TH
TP
VALVE
TERMINAL
BLOCK
Figure 10.7. Accessory wiring diagram.
Optional Remote Control 224910
When using a remote, the remote receiver should be wired to
the terminal block in the same way the as the thermostat. See
the instructions under Optional Wall Thermostat. The remote
receiver can be places on the bottom right of the Control
Compartment.
Follow the operating instructions included with the Remote
Control unit.
Figure 10.6. Remote Receiver Location. Shown with optional
blower.
ROCKER
SWITCH
ON
OFF
STAT
OPTIONAL
THERMOSTAT
or
REMOTE
CONTROL
130139_Rev 1 GF 520 DV 12/22
23
Advertisement
Table of Contents
