Table of Contents
Advertisement
10. Accessories
Reflective Black Glass Contents:
• Rear Panel ...................226763
• Cotton Gloves, 2
Instructions
•
INSTALL FUEL CONVERSION KIT BEFORE
INSTALLING PANEL KIT.
THE PANEL IS FRAGILE.
SUPPORT WITH BOTH HANDS.
HANDLE THE GLASS PANELS WITH THE COTTON
GLOVES PROVIDED TO MINIMIZE FINGERPRINTS.
SKIN OILS ARE DIFFICULT TO REMOVE FROM THE
GLASS SURFACE.
Figure 10.1. Install Rear Panel.
Tools:
• Flat head screw driver
•1/4" hex socket
ORIENT GLASS PANEL WITH THE
SMOOTH SIDE FACING OUT.
1. Set the Rear Panel, bottom first, behind the pilot assembly
shield and resting on the rear shelf. See fig. 10.1.
2. Use a flat head screwdriver to bend the rear tab at 45° to keep
glass from falling forward. See fig. 10.2.
3. Repeat the process for the tab on the opposite side.
NOTE: If the Glass Panel is installed in a location prone to
vibration, the retainer tab can be adjusted to hold the glass
tighter.
1. Remove the Baffle by removing the two M6 nuts in the upper
front corners of the firebox.
2. Use a 1/4" hex socket to loosen the screw on one of the
retaining tabs. Rotate the tab until it is holding the glass panel
tight to the firebox and tighten the screw.
3. Replace the Baffle.
Figure 10.2. Bend Side Tabs
130139_Rev 1 GF 520 DV 12/22
Retainer Tab
21
Advertisement
Table of Contents
