Jøtul GF 520 DV Installation And Operation Instruction Manual page 25

5. Attach the Blower to the brackets using two M6 flange nuts
as shown in fig 10.9.
6. Identify the Left Blower Assembly. The Left Blower assembly
has a solid plate on the front.
7. Attach the yellow connector from the Green Grounding
Strap to the prong at the bottom of the Right Blower Assem-
bly.
8. With the arrows facing up and out, rotate the Left Blower
Assembly behind the burner gas line onto the studs on the
blower brackets and secure with two M6 flange nuts. See fig
10.11
9. Secure the Green Grounding Strap to the rear of the control
box using the supplied sheet metal screw. See fig 10.12
10. Attach the Blower Control Box to the pilot holes in the
rear wall in the controls compartment using two sheet metal
screws provided. See fig 10.12.
CAUTION: DO NOT PINCH WIRES WHEN INSTALLING
CONTROL BOX!
11. Route the power cable plug through the square hole at the
bottom of the controls compartment.
Figure 10.11. Secure nuts on studs. Tighten securely.
Grounding Strap connection point
Figure 10.12. Blower Control Box and power routing.
Figure 10.13. Secure the Snapstat bracket securely.
130139_Rev 1 GF 520 DV 12/22
25