Jøtul GF 520 DV Installation And Operation Instruction Manual page 35

9. Install replacement side glass and gasket:
• Wrap the new gasket material evenly around the edge of
the glass, peeling back the protective strip to expose the
adhesive, leaving a 1/2" overlap at the end seam. Press the
adhesive side down onto the glass surface. Do not stretch the
gasket.
• Place the panel within the frame, ensuring the gasket seam
is on the top.
10. Replace the Side Glass Frame. Place the front of the frame
in the channel on the firebox then swing the frame onto the
four retaining studs. Using the four 10mm nuts previously
removed.
11. Replace the Side Assembly and tighten the two loosened
bolts on the inside front and back of the side assembly.
12. Replace the 10mm bolt and screw removed form the rear
top side of the side assembly.
13. Replace the front and top plates.
Figure 15.5. Loosen the bolt on the inside rear of the Side Assembly
Figure 15.6. Remove the side assembly and set aside.
Figure 15.7. Remove the nuts holding the glass frame.
130139_Rev 1 GF 520 DV 12/22
35