Jøtul GF 520 DV Installation And Operation Instruction Manual page 26

130139 Rev 1 GF 520 DV 12/22
12. Install the Snapstat Bracket to the stud at the bottom of the
firebox using the provided M6 flange nut.
13. Install the Snapstat into the bracket ensuring that it sits
flush on the firebox. If snapstat is not snug against the
firebox, the bracket may need to be bent by hand to make a
secure fit. See fig 10.14.
14. Install the black and blue wires from the control harness to
the Snapstat.
15. Bend the protective cover open enough to slide over the
snapstat.
16. Manipulate the Snapstat harness through the protective
cover then attach the protective cover assembly to the stud
at the bottom of the firebox using a second M6 flange nut.
Bend the cover shut. See fig 10.15.
17. Attach the 4 connectors from the wire harness to the four
terminals on the Left and Right Blower Assemblies.
18. Connect power cord to outlet.
Figure 10.14. Install Snapstat and attach pink connectors.
Figure 10.15. Install the Snapstat cover using a second M6 nut
and tigheten securely.
26
Blower Operation
The optional variable-speed blower will enhance heat
circulation around the firebox and out into the room. The
blower is controlled by a heat activated switch (snapstat)
that will ONLY function when the control switch is in AUTO
setting. After the fire has been burning for a time, the snapstat
will react to the heat and activate the blower. Fan speed may be
manually adjusted with the rheostat knob. If the burner turns
off, the blower will be shut off automatically when the stove
cools down.
If automatic blower circulation is not desired, place the
blower control switch in the MANUAL position.
Speed
Control
Figure 10.16. Blower Controls
G
W
G
BL
BK
POWER
GY
SUPPLY
P P
BL GY
AUTO OFF MANUAL
Figure 10.17. Blower Wiring Diagram
Manual or
Automatic
Modes
BLOWER
W BK
BK BK
P
BK
BK BK
P
RHEOSTAT
SNAPSTAT
BR
P
P = QuickConnector Pin
BR
SWITCH