Fuel Conversion - Jøtul GF 400 BV Sebago Installation And Operation Instructions Manual

Fuel Conversion

The Jøtul GF 400 BV gas stove is shipped from the factory
equipped to burn NATURAL GAS only. If PROPANE gas is
to be used as fuel, the appliance must first be converted
for use with propane. Use Propane Conversion Kit 156005,
supplied with the appliance.
Order and install NG Conversion Kit 156006 to change
back to use with natural gas.
WARNING:
THE CONVERSION KIT IS TO BE INSTALLED BY
AN AUTHORIZED JØTUL SERVICE TECHNICIAN
IN ACCORDANCE WITH THE MANUFACTURER'S
INSTRUCTION AND ALL CODES AND REQUIRE-
MENTS OF THE AUTHORITY HAVING JURISDIC-
TION. FAILURE TO FOLLOW THESE INSTRUC-
TIONS COULD RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE. THE QUALIFIED AGENCY
PERFORMING THIS WORK ASSUMES RESPONSI-
BILITY FOR THIS CONVERSION.
IN CANADA:
THE CONVERSION SHALL BE CARRIED OUT IN
ACCORDANCE WITH THE REQUIREMENTS OF
THE PROVINCIAL AUTHORITIES HAVING JU-
RISDICTION AND IN ACCORDANCE WITH THE
REQUIREMENTS OF THE CAN1-B149.1 AND .2
INSTALLATION CODE.
AVERTISEMENT:
Cet equipement de conversion sera installe par
une agence qualkfiee de service conformen-
ment aux instructions du fabricant et toutes
exigences et codes applecables de l'autorises
avoir la juridiction. Si l'informaiton dans cette
Instruction n'est pas suivie exactement, un
feu, explosion ou production de protoxyde de
carbone peut resulter le dommages causer de
propriete, perte ou blessure personnelle de vie.
L'agence qualifiee' de service est esponsable
de l'installation propre de cet equipement.
L'installation n'est pas propre et complete
jusqu'a l'operation de l'appareil converti est
cheque suivant les criteres etablis dans les
instructions de proprietaire provisionnees avec
l'equipement.
Tools required:
• 1/2" open ended wrench or deep-well socket, Torx T20
or slotted screwdriver, 4 mm allen wrench.
Conversion Kit Contents:
• 1, regulator tower labeled for propane
• 3, regulator tower screws
• 1, burner orifice (3.20 mm for NG, #49 for LPG)
• 1, pilot orifice (#51 for NG, #30 for LPG)
• Label A - to be completed and applied to
the back of the stove
• Label B - apply to the stove's Rating Plate
• Small valve label - apply to valve body
Conversion instructions are also shipped in the stove with the
conversion kit.
Fuel Conversion Procedure
1. Turn off gas supply to stove.
2. Remove the stove Top Plate.
3. Disengage the two Glass Frame Latches at the top of
the firebox. See illustration on page 5. Carefully lift
the glass panel up and out of the stove.
4. If installed, remove the Embers and Log Set using care
not to damage the fragile log parts.
5. Lift out the Burner Skirt shown in fig. 11.
6. Reach under the stove and remove the Air Shutter
wingnut from its stud. See fig. 12.
Burner Skirt
Figure 11. Lift and remove the Burner Skirt from within
the firebox.
Insulation Pad
Fender Washer
Wingnut
Figure 12. Locate and remove the Air Shutter wingnut
from under the right side of the stove.
138301_Rev_G 10.4.11
11