Hard Disk Drive - IBM x3250 M2 Problem Determination And Service Manual

10. Turn on all attached devices and the server.
11. See the documentation that comes with the Remote Supervisor Adapter II

Hard disk drive

Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this section.
Attention:
server cover is in place and fully closed whenever you install or remove a hard disk
drive.
Note: If a RAID controller or adapter is installed, you might have to reconfigure the
disk arrays after you install or remove hard disk drives. See the documentation that
comes with the adapter for more information.
Removing a simple-swap Serial ATA hard disk drive
Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To remove a simple-swap SATA drive from the bay, complete the following steps.
Hard disk
drive assembly
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server cover is in place and fully closed.
3. Turn off the server and peripheral devices, and disconnect the power cord and
4. Remove the filler panel from the bay.
5. Pull the loops of the drive tray toward each other and pull the tray out of the
7. Install the cover (see "Installing the cover" on page 51).
8. Slide the server into the rack.
9. Connect the cables and power cords.
SlimLine for information about installing the firmware and configuring the
adapter. If you have a backup copy of the configuration, restore the
configuration.
To avoid damage to the hard disk drive connectors, make sure that the
Simple-swap hard disk drives are not hot-swappable. Disconnect all
on page 47.
all external cables.
bay.
SATA hard disk
drive back plate
Filler panel
Chapter 4. Removing and replacing server components
59