IBM x3250 M2 Problem Determination And Service Manual page 38

v Event/Error Logs
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup
20
IBM System x3250 M2 Types 4190, 4191 and 4194: Problem Determination and Service Guide
information about error codes that occur. See the Problem Determination
and Service Guide on the IBM System x Documentation CD for
instructions. To clear the BMC system-event log, select Clear BMC SELs
and confirm the selection.
The BMC system-event log is limited in size. When the log is full, new
entries will not overwrite existing entries; therefore, you must periodically
clear the BMC system-event log. When you are troubleshooting an error, be
sure to clear the BMC system-event log so that you can find current errors
more easily.
– High Precision Event Timer
Select this choice to enable or disable the high precision event timer (HPET)
function.
Select this choice to view or clear error logs.
– System Event/Error Log
Select this choice to view the complete log of POST error messages. Use the
arrow keys to move among pages in the log.
Run the diagnostic programs to get more information about error codes that
occur. See the Problem Determination and Service Guide on the IBM System
x Documentation CD for instructions.
To clear the system event/error log, select Clear System Event/Error Log
and confirm the selection.
The system event/error log is limited in size. When the log is full, new entries
do not overwrite existing entries; therefore, you must periodically clear the
system event/error log.
– RSA II Event/Error Log
This choice is displayed only when a Remote Supervisor Adapter II SlimLine
is installed in the server.
Select this choice to view the system-error messages from the Remote
Supervisor Adapter II SlimLine.
To clear the RSA II event/error log, select Clear RSA II Logs and confirm the
selection.
The RSA II event/error log is limited in size. When the log is full, new entries
will overwrite the oldest entries. When you are troubleshooting an error, be
sure to clear the RSA II event/error log so that you can find current errors
more easily.
Select this choice to save the changes that you have made in the settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
Select this choice to exit from the Configuration/Setup Utility program. If you have
not saved the changes that you have made in the settings, you are asked
whether you want to save the changes or exit without saving them.