IBM x3250 M2 Problem Determination And Service Manual page 37

– RSA II Settings
This choice is displayed only when a Remote Supervisor Adapter II SlimLine
is installed in the server.
Select this choice to view the IP address, DHCP settings, and gateway
settings for the Remote Supervisor Adaptor II SlimLine, and to view or change
the DHCP control, static IP address, subnet mask, gateway static IP address,
and operating-system USB selections for the Remote Supervisor Adapter II
SlimLine.
– Baseboard Management Controller (BMC) Settings
Select this choice to change Intelligent Platform Management Interface (IPMI)
settings for the mini-BMC controller.
- IPMI Specification Version
This is a nonselectable menu item that displays the IPMI version.
- BMC Firmware Version
This is a nonselectable menu item that displays the BMC firmware version.
- BMC Build Date
This is a nonselectable menu item that displays the date that the BMC
code was created.
- BMC Build Level
This is a nonselectable menu item that displays the version of the BMC
code.
- Existing Event Log number
This is a nonselectable menu item that displays the number of entries in
the BMC system-event log.
- BMC POST Watchdog
Enable or disable the mini-BMC POST watchdog. Disable is the default
setting.
- System-BMC Serial Port Sharing
Select this choice to specify whether the serial port that the BMC uses is
shared with the rest of the system or is dedicated to the BMC. This choice,
together with the BMC Serial Port Access Mode setting, affects
serial-related behavior and remote-management capabilities on this server.
For more information, see the help for this choice.
- BMC Serial Port Access Mode
Select this choice to specify the access mode for the serial port. This
choice, together with the System-BMC Serial Port Sharing setting, affects
serial-related behavior and remote-management capabilities on this server.
For more information, see the help for this choice.
- Reboot System on NMI
Select this choice to enable or disable the ability of the server to restart
after an NMI interrupt is issued. If the value is Enabled, this setting
supersedes the automatic server restart (ASR) setting.
- User Account Settings
Select this choice to view the settings for each BMC user ID, change the
password for a BMC user ID, and set the maximum BMC privilege level.
- BMC Network Configuration
Select this choice to view the mini-BMC MAC address, IP address, subnet
mask, gateway address, host name, and DHCP control setting.
- BMC System Event Log
Select this choice to view the BMC system-event log, which contains all
system-error messages that have been generated. Use the arrow keys to
move among pages in the log. Run the diagnostic programs to get more
Chapter 2. Configuration information and instructions
19