IBM x3250 M2 Problem Determination And Service Manual page 80

Attention:
server cover is in place and fully closed whenever you install or remove a hard disk
drive.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server cover is in place and fully closed.
3. Install the hard disk drive in the hot-swap bay:
62
IBM System x3250 M2 Types 4190, 4191 and 4194: Problem Determination and Service Guide
Drive-tray assembly
Drive handle
(in open position)
To avoid damage to the hard disk drive connectors, make sure that the
on page 47.
Attention: To maintain proper system cooling, do not operate the server for
more than 10 minutes without either a drive or filler panel installed in each bay.
a. Make sure that the tray handle is open (that is, perpendicular to the front of
the drive).
b. Align the drive assembly with the guide rails in the bay.
c. Gently push the drive assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive status LED to make sure that the hard disk drive
is operating correctly. If the amber hard disk drive status LED for a drive is
lit continuously, that drive is faulty and must be replaced. If the green hard
disk drive activity LED is flashing, the drive is being accessed.
Filler panel