Ricoh IJM C180F User Manual page 161

To set up the printer with a computer DSL/ADSL modem
1. Obtain a DSL/ADSL filter from your DSL/ADSL provider.
NOTE:
service need to be connected to additional DSL/ADSL filters, to avoid noise when making voice calls.
2. Connect one end of the phone cord to the DSL/ADSL filter, and then connect the other end to the port
labeled
NOTE:
3. Connect the DSL/ADSL filter to the splitter.
4. Unplug the answering machine from the telephone wall jack, and connect it to the port labeled
back of the printer.
NOTE:
fax machine might be recorded on your answering machine, and you might not receive faxes with the
printer.
5. Connect the DSL modem to the parallel splitter.
6.
Connect the parallel splitter to the wall jack.
7. Set your answering machine to answer after a low number of rings.
8. Change your Rings to Answer setting on the printer to the maximum number of rings supported by the
printer.
NOTE:
9. Run a fax test.
When the phone rings, your answering machine answers after the number of rings you have set, and then play
your recorded greeting. The printer monitors the call during this time, "listening" for fax tones. If incoming
fax tones are detected, the printer emits fax reception tones and receive the fax; if there are no fax tones, the
printer stops monitoring the line and your answering machine can record a voice message.
If you use the same phone line for telephone, fax, and have a computer DSL modem, follow these instructions
to set up your fax.
If you encounter problems setting up the printer with optional equipment, contact your local service provider or
vendor for further assistance.
EN
Phones in other parts of the home/office sharing the same phone number with DSL/ADSL
on the back of the printer.
You might need to connect the phone cord to your country/region adapter.
If you do not connect your answering machine directly to the printer, fax tones from a sending
The maximum number of rings varies by country/region.
on the
Additional fax setup 149