Using The Lan To Access The Sci - Nortel IVR 2.5/S Manual

Using the LAN to access the SCI

To access an MRS across a LAN, the MRS must be connected to either an
Ethernet or Token Ring network, and the host that will access the MRS must
support TCP/IP and telnet (or rlogin).
To access the SCI, follow these steps:
1 At the host command line, enter the command: telnet
128.1.1.111
Note 1: If the Internet address for your MRS has been changed, enter
the correct Internet address instead of the default address shown. This
address is noted on your equipment list.
Note 2: If the host is an X Window-based UNIX workstation, Nortel
recommends that this command be issued from an xterm window.
2 Once the session is connected, the following message should display:
login:
3 At the login: prompt, enter the appropriate account name. The
default passwords for these accounts are as follows:
Account
root
service
admin
user
4 After you log in, the system prompts you for your terminal type. If the
default terminal type displayed is correct, press <Enter>; otherwise,
type in the correct terminal type.
Once this is completed, the SCI menu is displayed, followed by the
/sci> prompt.
Note: On an MRS/AP, if you log in as root, a # prompt is displayed. At
the # prompt, type /usr/vrs/tools/sci -b /usr/vrs and press
<Enter> to access the SCI menu.
Nortel IVR 2.5/S
Accessing the Service Console Interface A-5
Password
profile Trained Service Personnel
access Trained Service Personnel
supervise Site Administrators
nortel Routine Maintenance
Aculab-Based E1 CAS/ISDN PRI Signaling Guide
Used by