Using The Controller List Window - Nortel INM 5.0 User Manual

Procedure 3-1

Using the Controller List window

Use this procedure to use the Controller List of the user interface.
You can do the following:
• filter the list
• sort the list
The contents of all tabs in the user interface are a static snapshot of the status
at the instant that the view was created, as shown in the Controller list. Select
the Refresh key to update the view.
Requirements
Before you start, you must be at the Network Wide Backup & Restore window.
Action
Step
1
2
Network Wide Backup & Restore User Guide 450-3101-031 Rel 1.0 Standard June 1999
Administration of Network Wide Backup & Restore 3-3
Action
Determine your action.
If you want to
filter the Controller List
sort the Controller List
refresh the screen information
Select any combination of the boxes in the Controller List:
• All - the system will display all the controllers
• OPC - the system will display only the OPC controllers
• NPC - the system will display only the NPC controllers
• EC-1 - the system will display only the EC-1 controllers
• Other
—continued—
Then go to
step 2
step 3
step 4
3