Nortel Meridian Meridian 1 Implementation Manual page 67

• Parity: No
• Flow control: none
Note: Do not use XON/XFF flow control.
The next step is to define IP parameters using the CLI.
Procedure 13
Configure initial card parameters using the CLI
1 From the VT-100 type terminal press the Enter key.
The logon window appears.
2 At the login prompt, enter the following:
admin
Where "admin' is the default administrator password.
3 Access the System Administration menu. Enter:
SA
The System Administration menu opens.
4 Access the System Attributes Editor. Enter:
SY
The System Attributes Editor opens.
5 Enter the following IP attributes for the MICB card:
• Subnet mask – The part of the IP address which represents a subnetwork
within a network. The subnet mask has a format of XXX.XXX.XXX. XXX,
where XXX is in the range 0-255. Subnet mask in binary presentation of
32 bits has at least the first eight digits "1" and the last digit is "0".
• Gateway address – Is in the XXX.XXX.XXX.XXX format, where every
token is in the range 0-255.
• IP address – The internet protocol address which has the same format as
the gateway address.
6 Enter S to save the parameters.
7 Exit the CLI and proceed to Procedure 14. All other card configuration is
performed from the BUI.
Procedure 14
Access the administration BUI
1 Check the installation by doing the following:
a Run a browser, either Netscape or Microsoft Internet Explorer.
Meridian Integrated Conference Bridge
This procedure is now complete
This procedure is now complete
Service Implementation Guide
Page 67 of 208