Page 62 of 208
Procedure 4
Install the Ethernet Adapter card
1
2
3
4
5
6
7
Table 12 lists the pin number assignments for the Maintenance terminal
cable that connects the IPE module I/O panel that the following
procedures use. The cable connects to the nullmodem for direct
terminal connection or to a modem for a remote maintenance terminal.
Table 12
Maintenance cable
J2 DB-25 pin
J1 50-pin
1
2
3
4
5
6
7
8
9
10
11
12
13
553-3001-358
Standard 1.00
Remove the cover plate from the I/O panel at the rear of the IPE module.
Remove the I/O panel retaining screws and lift the I/O panel from the module.
Set up the I/O panel filter connector for the card slot you have assigned for
the MICB card installation.
Your next step depends on the configuration of that filter connector.
a
If this connector has a permanent connection to the backplane cable,
remove the filter connector from the I/O panel.
b
If a 50-pin connector joins the filter connector and the backplane cable,
disconnect the 50-pin connector from the I/O panel filter connector. Then,
being careful to save the retaining screws, remove the filter connector
from the I/O panel.
Install the NT5D52AC Ethernet Adapter card into the selected I/O panel
connector cutout using the saved retaining screws.
Fasten the I/O panel to the module using the retaining screws.
Replace the module cover plate.
Description
25
Reserved
22
RS-232 Tx
20
RS-232 Rx
18
Reserved
10
Reserved
16
Reserved
21
GND
17
Reserved
11
Reserved
24
LAN_Tx+
49
LAN_Tx-
12
Reserved
23
LAN_Rx+
October 2003
This procedure is now complete
J2 DB-25 pin
14
15
16
17
18
19
20
21
22
23
24
25
J1 50-pin
Description
48
LAN_Rx-
13
Reserved
14
Reserved
15
Reserved
36
Reserved
37
Reserved
19
Reserved
38
Reserved
39
Reserved
40
Reserved
41
Reserved
N.C.
Not Connected