Nortel Meridian Meridian 1 Implementation Manual page 34

Page 34 of 208
Each MICB card, using the direct meeting access method, requires the
following:
•
•
•
Full 62-port dual-card conferencing, using the direct meeting access
method, requires the following:
•
553-3001-358 Standard 1.00
One ACD group for each MICB card.
Assign ACD agent TNs/LENs and corresponding M2616 digital
sets. Each configured MICB port appears as an M2616 digital set of
an ACD agent. The number of TNs/LENs is equal to the maximum
number of ports provided by the MICB card. For an MICB with 32
ports active, the configuration requires 32 TNs/LENs. TNs/LENs
require 32 DNs for the ACD incalls key and 32 DNs for the
secondary directory number (SDN) key (Key 2).
An MICB card configured to the maximum capacity of 32 ports and
10 simultaneous conferences requires 87 ACD DNs and 32
TNs/LENs as follows:
— one ACD DN assigned to the MICB card
— 32 TNs/LENs assigned to the 32 ports (1 PDN and 1 SDN for
each TN/LEN; these can be internal DNs – non-DID)
— 20 ACD DID DNs (10 DN pairs) for dialing into the potential
conferences
Note: For single-number access, replace this with 1 DN.
— 1 DN for TUI access
Two MICB cards and six ACD groups as follows:
— 64 ACD agents (32 for each card), non-DID
— 64 secondary DNs for these agents, non-DID
— 36 DNs for simple conferences (9 pairs in each card)
Note: For single-number access, replace this with 2 DNs (1
for each card).
— 1 DN for dual-card conference access
— 1 DN for dual-card chairperson access
— 1 DN for the link DN, non-DID
October 2003