Nortel Meridian Meridian 1 Implementation Manual page 148

Page 148 of 208
Table 36
Commands to enable/disable MICB channels (Part 2 of 2)
Command
LOOP
STAT
UNTT
Meridian SL-100 diagnostic commands
Each card performs diagnostic tests as part of the daily routines.
Diagnostic tests can be activated from the MAP terminal on the
Meridian SL-100. The MICB card appears as an extended digital line
card to the system. For the diagnostic routine to pass in the LTP level
of the MAP terminal, the feature Communicator must be assigned
assigned to key 1 of the LEN.
Table 37 lists commands used to control the MICB status and functions.
Table 37
Meridian SL-100 commands to enable/disable MICB channels
Command
Bsy Card x/ RTS card x
Tst
QueryPM Inven Card x
Bsy
Bsy INB
RTS
Note: During a one night Process (ONP), a no restart switch activity
(SWACT) to the other central processing unit (CPU) drops active
calls on the MICB card. A warm SWACT of the front end during
maintenance activities does not affect active calls on the MICB card.
553-3001-358 Standard 1.00
Operation performed
Performs a network memory test, continuity test, and
signaling test on the specified loop.
Get status of specified card/channel.
LD 30
Performs self-test on the MICB.
Operation performed
IPE MAP Level
Disable/enable specified card.
Perform a network memory test, continuity test, and signaling test on the
specified loop.
Get status of specified card.
LTP MAP Level
Make the LEN or DN busy.
Take the port out of service. The system does not generate alarms.
Bring the MICB port in-service.
October 2003