Administration Terminal Maintenance Commands; Maintenance Features - Nortel Meridian Companion Installation And Maintenance Manual

Administration Terminal maintenance commands

Maintenance programming enables you to monitor and control Meridian
Companion operation at a hardware component level: system, card, WTN
TCM device.
All maintenance functions described in this section start at the Maintenance
menu. To access the Maintenance menu through the Administration Terminal
1.
2.
3.
4.
To access maintenance functions through Companion Manager, refer to
Companion Manager Installation and Operations Guide.

Maintenance features

There are six features in the maintenance menu.
•
•
•
•
•
•
The first four features are typically used when a problem or a system change
occurs. The two log features should be used to verify, record, and clear the
corresponding logs periodically.
The softkeys common to many of these tasks are labeled ENBL (enable) and
DSBL (disable). The confirming messages associated with the DSBL key are
Press ƒ••‚ . The display shows Password: .
Enter the Installer password. The display shows A. Configuration .
Press * until the display shows C. Maintenance .
Six features can be accessed at this point. See the following section for
a description of each.
To end a session, press ® .
system status
card status
WTN status
TCM status
Event/Alarm log
Administration log
Meridian Companion Installation and Maintenance Guide
Maintenance Page 125 of 206