Nortel Meridian Companion Installation And Maintenance Manual page 154

Page 144 of 206 Maintenance
553-3601-220 Standard 4.00 November 1998
Press * . The display shows Re-Eval schedule .
6.
Press ^ . The display shows the time and date when System
7.
Reevaluation has been scheduled, or the display shows
Not scheduled .
— If the time and date displayed are correct, press % three
times to continue in Configuration programming.
— To schedule System Reevaluation or change the scheduled time, go
to step 2 of "Setting a scheduled time or date".
— To cancel a scheduled System Reevaluation, press CANCEL .
Setting a scheduled time or date
Note: The system accepts only a date and time set later than the current date
and time.
1. Complete steps 1 to 7 of "Verifying the scheduled time".
2. Press CHANGE . The display shows Calls will drop at set time
followed by the current scheduled hour, or 0:01 if a time has not been
scheduled.
If you do not want to change the scheduled time, go to step 4.
3. To schedule the time, press CHANGE . The display shows Hour: followed
by the current scheduled hour (00 if none scheduled).
a. Press CHANGE . The display shows Hour: . If you do not want to
change the hour, go to step 3c.
b. Enter the hour in 12-hour or 24-hour format, as one or two digits.
c. Press * . The display shows Minutes: followed by the
current scheduled minutes (01 if none scheduled). If you do not want
to change the minutes, go to step 3f.
d. Press CHANGE . The display shows Minutes: .
e. Enter the minutes as one or two digits.
f. Press * . If you entered an hour less than or equal to 12, the
display prompts you with AM or PM . If you entered an hour greater
than 12, go to step 4a to set the date or go to step 5 to continue in
Configuration programming.