Wtn - Nortel Meridian Companion Installation And Maintenance Manual

Page 86 of 206 Programming the Meridian Companion system

WTN

553-3601-220 Standard 4.00 November 1998
Changing PCM modes
Press ƒ••‚ and enter the Installer password.
1.
Press ^ . The display shows 1. Telephony Data .
2.
Press ^ , then * until the display shows PCM mode
3.
4. Press CHANGE to switch between Mu Law and A Law. The last value
displayed is automatically set.
If the value hasn't changed, press * to continue Mobility data.
5.
If the value has changed, a warm reset is required. Press APPLY. The
display shows Warm Reset?.
6. Press RESET to begin warm reset.
Note: CANCEL does not save the change and does not initiate a warm
reset.
With X11 release 24 and the MC32 feature (package 350), the number of
wireless terminals per card can be changed from 16 to 32.
Changing the number of wireless terminals per card
Press ƒ••‚ and enter the Installer password.
1.
From A. Configuration , press ^ . The display shows
2.
1. Telephony Data .
Press ^ , then * until the display shows 16 WTN or
3.
32 WTN.
Press * to continue in telephony data if the number of wireless
4.
terminals per card is correct, or press CHANGE until the correct number
of wireless terminals per card is displayed (either 16 WTN or 32 WTN).
5. Press APPLY when the correct number of wireless terminals per card is
displayed. The display shows
6. Press RESET to save the change and begin a warm reset.
Note: CANCEL does not save any of the changes and does not initiate a
warm reset.
Warm Reset?
.