Nortel BayStack 820 Installation And Reference Manual page 237

Table B-1. System Messages
Message
Remote IP address already existed.
Remote IPX network number already
existed.
Remote name already exists.
Remote name is required.
Remote phone number unspecified.
Remote phone number is unspecified.
The remote system name already
exists. Please change to another user
name.
Resetting system, please wait...
Routing Table too large for complete
display. Please use CLI.
Save configuration failed. Please try
again.
Save configuration succeeded.
Searched entry exists.
Search fail.
Sorry, the router is already being
managed by "xxx.xxx.xxx.xxx."
Concurrent management is not
allowed!
The specified tunnel is incoming only.
SpeedDial Number not added.
The SpeedDial number should start
with a non-zero number.
SPID1 (or SPID2) unspecified.
206901-A
(continued)
Meaning
A duplicate IP address has been entered.
A duplicate IPX network number entry has been entered.
A duplicate remote name has been entered. The remote name in
the tunnel configuration must be unique.
Enter a remote name. This is a required parameter in a VPN tunnel
configuration.
Enter a remote phone number. This is a required parameter.
A remote phone number has not been provided in a profile where it
is required for the completion of the configuration.
A duplicate user name has been entered. Dial-in user names must
be unique.
The router is in the process of resetting. You can log on to the
router after about 30 seconds.
The current size of the IP routing table is too large for a complete
display. To view the complete IP routing table, use the
routing table
CLI command.
The system failed to save the configuration. Try again.
The configuration was successfully saved to flash memory.
The IP route being added already exists.
An internal error has occurred.
Another Web browser management session is active on the
workstation with the specified address. The system only allows
one management session at any given time.
A tunnel profile defined as Incoming Only cannot be used in an
outgoing VPN profile.
The speed dial number is missing. This a required parameter.
An extension number or a speed dial number cannot start with a
zero (0).
The specified SPID is missing. This is required in the ISDN port
configuration. If you selected NI-1, DMS-100, or ATT5EE
(Multipoint) as your ISDN switch type, you need to configure both
SPID numbers.
System Messages
show IP
B-9