Ipxping <Remote_Network_#> <Remote_Macaddr> <Repeat_Count; Ping <Ipaddr> [<N_Times> < N_Size>]; Set Log Level <1-10; Test Isdn <Directory_Number> <56K | 64K - Nortel BayStack 820 Installation And Reference Manual

ipxping <remote_network_#> <remote_MACaddr> <repeat_count>
Performs an IPX ping (a diagnostic message to be echoed by the receiving device)
to a remote IPX node, which is on the specified remote IPX network
(remote_network_#), with the specified MAC address (remote_MACaddr). The
ping is performed the specified number of times (repeat_count).
<IPaddr>
ping [<n_times> < n_size>]
This command allows you to ping an IP device (send a diagnostic message to be
echoed by the receiving device). You can optionally specify the number of times
the ping is performed (n_times) and the size of the packet to be sent each time
(n_size). If you do not specify these optional parameters, the ping is executed only
once with a packet size equal to 56 bytes.
The maximum value for
If you specify a larger value for either parameter, it is reset to the appropriate
default.
Example
BayStack> ping 10.0.0.2 100 1000
repeating times = 100, data length = 1000
Ping packets -- total: 100
BayStack> ping 10.0.0.2
repeating times = 1,
Ping packets -- total: 1
set log level <1-10>
Changes the system log level, causing different events to be logged into the
system log table. This command is often used for troubleshooting the router.
The default log level is 2, which means all events belonging to log level 2 or
below are included in the system log.
test isdn <directory_number> <56k | 64k>
Initiates an ISDN call based on the specified calling information, which includes
the ISDN Directory Number, and the data service supported by the remote and
local phone switch. The call is cleared immediately after a connection is
established.
206901-A
is 100. The maximum value for n_size is 1932.
n_times
sent: 100 received: 100
data length = 56
sent: 1 received: 1
Using the Command Line Interface
10-15