Nortel BayStack 820 Installation And Reference Manual page 230

Installation and Reference for the BayStack 820 ISDN Router
Table B-1. System Messages
Message
An IPX Network Number is an 8 digits
hexadecimal number.
Apply configuration. Please wait... This
action may take some minutes.
Applied parameter accepted.
Before creating a new profile, you must
first configure ISDN.
Before creating a new profile, yoU must
first configure the VPN tunnel.
Browser failed to send out user's
command. Please try again.
Browser's connection has been lost.
You can reconnect system by opening
'http://***.***.***.***'
Browser's passing command failed.
Please try again.
Call operation in progress. Request
ignored.
Cannot perform operation. Port or
profile is currently disabled.
Can't disconnect LAN.
Can't disconnect voice call.
Can't perform operation. The line(s) is
still initializing.
Can't disconnect this type of
connection.
Can't find the selected connection
profile.
Clear system configuration and restart,
please wait...
The confirmed encryption key doesn't
match.
B-2
(continued)
Meaning
A valid IPX network number can only contain hexadecimal
numbers, (0-9, a-f) and may be up to 8 characters in length.
The changes made requires interaction with the external ISDN
switch. This may take a few minutes depending upon the timing of
the responses received from the switch.
The changed parameters have been applied to the router
configuration.
The ISDN port must be configured before a connection profile
(which uses the ISDN line) can be configured.
At least one VPN tunnel is required before you can configure any
VPN profiles.
A temporary error has occurred while trying to communicate with
the router. Repeat the operation.
You must reenter the indicated IP address in order to reestablish a
management session with the router.
A transient error occurred during the communication between the
Web browser workstation and the router. Repeat the operation.
You clicked Apply and Test or Connect when a call is already
connected.
An outgoing call was attempted on a port or profile that is disabled.
You tried to disconnect the LAN interface.
You tried to disconnect a voice call. You can disconnect only data
calls.
The ISDN auto detection sequence is still in progress. You must
wait until this completes before attempting to invoke a connection
profile. The operation is complete when the Power LED stops
flashing and glows green.
You tried to disconnect a non-switched connection profile. This
type of profile connection cannot be manually disconnected.
Internal error. You must delete this profile and recreate the profile.
Please report this problem to customer support.
The router is in the process of clearing all system configurations
and resetting.
The encryption key entered in the Confirm Encryption Key field is
not the same as the key in Encryption key field.
206901-A