Procedure
1.
Connect the equipment required as shown below.
USB flash drive
BKM-17R
12V DC
2.
Set the NETWORK switch of the controller and the monitor to PEER TO PEER.
3.
Login to PC.
4.
Setup the PC. (Refer to
5.
Check the network connection.
(1) Open the command prompt.
(2) Input "ping
< IP address of the monitor > ".
(3) Input "ping
< IP address of the controller > ".
• If an error appears on the screen, carry out step 6 and subsequent steps.
• When there is no problem with the network, perform "Software data writing procedure" below.
BVM-E171
LAN cable
LAN cable
"1-4-4. PC
Setting".)
Switching HUB
LAN cable
PC
5-10