Table of Contents
Advertisement
4.
Set the NETWORK switch of the unit and controller to "PEER TO PEER".
5.
Setup the PC. (Refer to
6.
Setup the host. (Refer to
Tip
For [Local initial folder], specify the folder that contains the model name file and the serial number file.
Procedure
1.
Turn on the unit.
2.
Startup the FFFTP.
3.
Overwrite and upload the model name file and the serial number file in the following folder of the host (this unit).
Folder name: /flb1/data/adj
4.
After the upload has been completed, click [View(V)] - [Renew the latest information (R)] on the menu bar.
5.
Check whether the file information has been updated.
6.
Turn off the unit.
Check the Model Name and Serial Number
Procedure
1.
Display the main menu. (Refer to the operating instructions for the unit.)
2.
Select [System Status].
3.
On the screen that opened, check whether [Model Name] and [Serial No] are equal to the model name and serial
number shown on the name plate of the unit.
Date/Time Setting
Set Date/Time. Refer to the instruction manual for the setting procedure.
Software, Kernel, and FPGA Upgrade
Upgrade the software, kernel, and FPGA as required to the versions of the unit before replacement. (Refer to
Upgrade
Method".)
If upgrading from USB flash drive or Memory Stick is disabled, refer to
BVM-E171
"1-4-4. PC
Setting".)
"1-4-5. Host (FTP)
Setting".)
"5-2. Recovery from Upgrade
"5-1.
Failure".
4-21
Advertisement
Table of Contents
