4-5.
Bottom Cabinet Assembly
Preparation
1.
Remove the rear cover assembly. (Refer to
2.
Remove the power block. (Refer to
Procedure
1.
Remove the four screws (PSW3 x 6), then remove the VESA bracket assembly.
2.
Remove the harness from the clamper.
3.
Disconnect the harness from the connector (CN300) on the ST1 board.
4.
Remove the three screws (B3 x 5) and three screws (K3 x 5), then remove the bottom cabinet assembly.
VESA bracket assembly
PSW
3 x 6
5.
Install the removed parts by reversing the steps of removal.
BVM-E171
"4-3. Rear Cover
Assembly".)
"4-4. Power
Block".)
PSW
3 x 6
Clamper
CN300
Harness
ST1 board
Upper side
K3 x 5
Bottom cabinet assembly
B3 x 5
4-6