Table of Contents
Advertisement
2.
Connect the devices in use as shown in the figure below.
USB flash drive
BKM-17R
12V DC
3.
Set the NETWORK switch of the unit and controller to "PEER TO PEER".
4.
Setup the PC. (Refer to
Procedure
1.
Turn on the unit and wait for at least two minutes.
Tip
When upgrading the FPGA failed or FLASH (IC1203) is replaced, no information is displayed on the screen and
the front indicator blinks showing an error.
2.
Run the TeraTerm and perform the MR6 command connection from the PC. (Refer to
Commands from the
PC".)
Tip
When upgrading the FPGA failed, [login:] may not appear. In that case, FPGA_CORE may be damaged. Perform
"5-2-2. Recovery Procedure When Upgrading the Unit's Kernel or FPGA
BVM-E171
LAN cable
LAN cable
"1-4-4. PC
Setting".)
Switching HUB
LAN cable
PC
"1-4-6. Connecting
Failed".
5-7
Advertisement
Table of Contents
