4-12.
YA Board
Preparation
1.
Remove the rear cover assembly. (Refer to
2.
Remove the power block. (Refer to
3.
Remove the bottom cabinet assembly. (Refer to
4.
Remove the G board. (Refer to
5.
Remove the BA board. (Refer to
6.
Remove the DC fan. (Refer to
7.
Remove the bezel assembly. (Refer to
Procedure
1.
Remove the two screws, then remove the YA board.
2.
Disconnect the harness from the connector (CN1201) on the YA board.
B3 x 5
CN1201
Harness
3.
Install the removed parts by reversing the steps of removal.
BVM-E171
"4-3. Rear Cover
"4-4. Power
Block".)
"4-5. Bottom Cabinet
"4-8. G
Board".)
"4-9. BA
Board".)
"4-10. DC
Fan".)
"4-11. OLED Module Assembly and Bezel
YA board
Assembly".)
Assembly".)
Assembly".)
Upper side
4-15