Replacing Drive Belt - Sl; Replacing Tensioning Device - Sl110 - Kohler KD103V20 Operation And Maintenance Manual

u Release and remove ratchet wrench.
w The tensioning device is released.
Fig. 52: Checking drive belt tension — Measurement area
1 Sensor
u Check tension with frequency meter. The measured frequency value must be 165 Hz (Min 149
Hz - Max 182 Hz).
In case of air conditioning compressor installed, proceed in the same way.
Information
Install battery charging alternator cover in reverse sequence.
5.8.1 Removing the battery charging alternator cover, page 106.)
5.8.4 Replacing tensioning device — SL110
q Battery charging alternator cover is removed.
battery charging alternator cover, page 106.)
q Drive belt is removed.
page 108.)
q New tensioning device is available.
KD103V20 33521030901_2_1 EN_US
2022-09
(For more information see: 5.8.3 Replacing drive belt — SL 109,
© 2022 by Kohler Co. All rights reserved.
Generic maintenance activities
2 Belt section
(For more information see:
(For more information see: 5.8.1 Removing the
Maintenance
109