Service Level 1 - Engine Service, Tbo 15000 Hours For Prp - Engine Operation - Version: 2018-07 - Kohler KD103V20 Operation And Maintenance Manual

5.4.4 Service level 1 — Engine Service, TBO 15000 hours for PRP —
Engine Operation - Version: 2018-07
Component
SL100 Oil sampling
SL120 Coolant sampling
Recommended:
First 250 service
SL122
hours for a new or
overhauled engine
Engine oil filters
standard - main
SL101 bearing with
engine oil "Cate‐
gory 3"
Engine oil change
with engine oil
SL121
"Category 2" (2)
KD103V20 33521030901_2_1 EN_US
2022-09
Service
Schedule
Type
250 1Y X
- 2Y X
250 1Y X X
Without centrifugal oil filter
250 2Y X
250 2Y X
© 2022 by Kohler Co. All rights reserved.
Inspection and maintenance schedules
Task description
Collect and send oil sample for analysis every 100
hours on ESP or 250 hours (in PRP and COP applica‐
tions). If the results are not within the requested
parameters, repeat analysis at shorter intervals. In
case of use of high sulfure rate (>0.5%). No oil
Category 1 in case of K175.
see: 5.9.1 Collecting and analyzing oil sample —
SL100, page 111.)
Check coolant quality.
5.10.1 Collecting coolant sample — SL120,
page 122.)
Engine oil replacement
5.9.6 Changing Diesel engine oil — SL101, SL121,
page 118.) .
Oil filters and oil filters for cooling jet replacement.
(For more information see: 5.9.4 Changing oil filters
— SL101, page 113.)
It is recommended to check the engine oil charac‐
teristics at the same time.
see: 5.9.1 Collecting and analyzing oil sample —
SL100, page 111.) .
Perform all check before starting and perform a
test run.
Replace filters. Clean the seal area before removal
the old filter to prevent oil contamination.
information see: 5.9.6 Changing Diesel engine oil —
SL101, SL121, page 118.)
Oil change maximum interval. Note: Replace engine
oil at least every 2 years. Final engine oil interval
depends on exchange interval factor according to
engine oil category and fuel sulfur rate. 0<fuel
sulfur rate<0.5%: the factor is 1 (no change on the
engine oil change interval). 0.5<fuel Sulfur rate<1%:
the factor is 1/2 (reduce by 2 times the engine oil
change interval and use only engine oil category 2
or 3). 1<fuel sulfur rate <1.5%: requires additional
approval. No oil Category 1 in case of K175.
more information see: 5.9.6 Changing Diesel engine
oil — SL101, SL121, page 118.)
Maintenance
(For more information
(For more information see:
(For more information see:
(For more information
(For more
(For
89