Changing Diesel Engine Oil - Sl101, Sl121 - Kohler KD103V20 Operation And Maintenance Manual

Maintenance
Lubricating system
Fig. 64: Assembling rotor
u Assemble rotor cylinder 5 on rotor base 7.
u Mount rotor cover 8 and tighten nut to 40 Nm (30 ft-lb).
Fig. 65: Assembling the centrifuge
u Place rotor 3 in centrifuge base 1.
u Install cover 4 and tighten nut to 13 Nm (10 ft-lb).
u Check seal of V-clamp 2. Replace if necessary.
u Install and tighten V-clamp 2 to 15
u Start and run engine for three minutes.
u Check engine oil level.
SL001, page 112.)
5.9.6 Changing Diesel engine oil — SL101, SL121
q Preparatory maintenance activities are fulfilled.
maintenance activities, page 97.)
q A container with the required capacity is ready.
q Original KOHLER oil filters with the seals are available.
q A suitable drainage container is available.
118
Nm (11 ft-lb).
±2 ±1
(For more information see: 5.9.3 Checking the engine oil level —
© 2022 by Kohler Co. All rights reserved.
(For more information see: 5.5 Preparatory
KD103V20 33521030901_2_1 EN_US
2022-09