Siemens SIMATIC ET 200SP Manual page 27

Configuring/address space
4.2 Parameter setting
Parameters of the TM PTO 2x24V
The following parameter settings are possible. The default settings of the parameters are
shown in bold in the "Value range" column.
Table 4- 1
Potential group
Signal type
Interpulse period following
auto reverse
Enable diagnostic
interrupts
Increments per
revolution
Reference speed
Bits in incr. Actual value
(G1_XIST1)
Maximum speed
Quick stop time (OFF3)
Ramp stop time (OFF1)
Use ED as Enable Drive
Use RS as reference switch
Reference switch
edge selection
Use MI as measuring input
Use DR as Drive Ready
26
Programmable parameters
Parameter
1
•
•
•
•
•
•
•
•
•
•
•
•
1...200...1000000
1.0...3000.0...20000.0 rpm
0 (read-only)
Depending on signal evaluation, increments
per revolution and reference speed (see follow-
ing table):
3000.0 rpm
1...1000...65535 ms
1...5000...65535 ms
•
•
•
•
•
•
•
•
•
•
Value range
Use potential group of the left module
(dark BaseUnit)
Enable new potential group (light BaseUnit)
PTO (Pulse (P) and direction (D))
PTO (count up (A), count down (B))
PTO (A, B phase-shifted)
PTO (A, B phase-shifted, quadruple)
0 ms
1 ms
4 ms
10 ms
Deactivated
Enabled
Deactivated
Enabled
Deactivated
Enabled
At positive edge
At negative edge
Deactivated
Enabled
Deactivated
Enabled
Technology module TM PTO 2x24V (6ES7138‑6EB00‑0BA0)
Equipment Manual, 09/2021, A5E50983437-AA
Scope
Module
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel