Connecting; Pin Assignment - Siemens SIMATIC ET 200SP Manual

Connecting

3.1

Pin assignment

The TM PTO 2x24V technology module is used with a BaseUnit of type A0 (article number
6ES7193-6BPx0-0xA0).
Connect the pulse output signals, digital input signals and digital output signals to the
BaseUnit of the technology module. The supply voltage feed on the light-colored BaseUnit
BU...D of the associated potential group supplies the module and the digital outputs.
BaseUnit
The BaseUnit is not included in the scope of delivery of the module and must be ordered
separately.
For an overview of the BaseUnits to be used with the technology module, refer to the product
information on the documentation for the ET 200SP Distributed I/O System
(http://support.automation.siemens.com/WW/view/en/73021864).
You can find information about selecting a suitable BaseUnit in the ET 200SP Distributed I/O
system (http://support.automation.siemens.com/WW/view/en/58649293) system manual and
ET 200SP BaseUnits (http://support.automation.siemens.com/WW/view/en/58532597/133300)
equipment manual.
You can find information on wiring the BaseUnit, connecting cable shields, etc. in the Wiring
section of the ET 200SP Distributed I/O system
(http://support.automation.siemens.com/WW/view/en/58649293) system manual.
Supply voltage L+/M
With a light-colored BaseUnit, you connect the supply voltage to the L+ and M terminals. With
a dark BaseUnit, the supply voltage of the left-hand module is used. An internal protective
circuit protects the technology module from polarity reversal of the supply voltage. The
technology module monitors the connection of the supply voltage.
Technology module TM PTO 2x24V (6ES7138‑6EB00‑0BA0)
Equipment Manual, 09/2021, A5E50983437-AA
3
17