Skoda OCTAVIA 2004 Workshop Manual page 95

OCTAVIA
Initiate basic setting
1 2 3 4 5
Edition 12.00
S00.5111.54.20
Fuel Formation/Fuel Injection
0
→
6 8 9 10
t
commencement
Notes:
♦ Commencement of injection must always be
checked and set, if necessary, after replac-
ing the toothed belt or also after slackening
the bolted connections at the injection pump
or at the toothed belt sprockets.
♦ Dynamic testing of commencement of injec-
tion is only possible in function 04 „Basic
setting of engine“ as, during this function, the
commencement of injection valve is con-
stantly actuated and the injection timing de-
vice is thus „retarded“.
t t
♦ Vehicle system tester V.A.G 1552 with cable
V.A.G 1551/3, 3A, 3B or 3C
♦ Torque wrench 5...50 Nm (e.g. V.A.G 1331)
♦ Counterholder MP 1-216
♦ Locking pin 3359
- Select function „Basic setting“, display group
001 ⇒ page 01-21.
K - Check readout in display block 7 (coolant
temperature).
Specification: less than 73 (equals 85 °C)
Do not continue with the test until the coolant
temperature is reached.
ä
- Commencement of injection in display block
2 is dependent on the fuel temperature in
display block 9.
Specification: ⇒ Figure - range C
K
A - Display block 2, commencement of injec-
tion
B - Display block 9, fuel temperature
C - Specified range for commencement of in-
jection
and
injection
and
------------
23
------------