Skoda OCTAVIA 2004 Workshop Manual page 12

01
Fault number: 00542
Needle lift sender -G80
Short-circuit to earth
Vehicle system test
Select function XX
------------ 01-6 -------------
Self-Diagnosis
If one or several faults are stored:
- → Press key.
K Read-out of fault number on display, e.g.:
→
- → Press key.
K Fault source and fault type appear in the dis-
→
play, e.g.:
- → Press key.
The stored faults are displayed in sequence.
- → Press key.
HELP K Read-out on display:
- Enter 06 for the function “end output” and
confim entry with key Q.
- Rectify fault by referring to the fault table
⇒ page 01-8.
Note:
When carrying out test and removal and instal-
lation operations, faults, such as connectors
unplugged, may also be detected by other con-
trol units. This is why, when the work is con-
cluded, that it is necessary to interrogate and
erase the fault memory on all control units. For
this you must proceed as follows:
- Enter 00 twice for the address word “Auto-
matic check sequence” and confirm entry
with Q key. The -V.A.G 1552- sends all known
address words in sequence.
Erasing fault memory
Test condition
l Rectifying fault
Note:
After fault elimination the fault memory must
again as described be interrogated and subse-
quently erased.
For vehicles 08.03 ä
Whenever the fault memory is erased, it is nec-
essary to generate a readiness code ⇒ page
01-26.
- Connect vehicle system tester -V.A.G 1552-
and select the engine electronics control unit
(address word 01). The engine must be run-
ning in idle.
(Connect vehicle system and select engine
electronics control unit ⇒ page 01-2).
OCTAV1A
Edition 01.04
S00.5111.56.20