Skoda OCTAVIA 2004 Workshop Manual page 89

OCTAVIA
Edition 03.98
S00.5111.52.20
Fuel Formation / Fuel Injection
- Remove the top toothed belt guard, the
vacuum pump and the cylinder head cover.
- Remove sound-absorbing pan and air guide
pipe between intercooler and turbocharger.
Engine installed
- Take off cover at inspection opening.
K - Position the crankshaft to TDC of cylinder 1
-arrow-.
Engine placed down on floor
K - Screw in setting device for TDC point (MP
1-313, as shown in the illustration.
- Set setting device to 96 mm -arrow- (the left
notch of the vernier -arrow A- is the refer-
ence point).
- Rotate crankshaft until TDC marking -arrow
B- on the flywheel is aligned with the edge of
the setting device.
Engine attached to engine holder MP 1-202
K - Position flexible steel ruler (marking tool)
against the circumference of the flywheel.
- Measure exactly 100 mm from the TDC
marking -arrow A- and make a mark -arrow
B- as an aid with marking tool.
23
------------ ------------