OCTAV1A
Vehicle system test
Fault memory is erased
Reading measured value block
2500/rpm
4.6 mg/h
Reading measured value block
1650/rpm
4.1 mg/h
Edition 01.04
S00.5111.56.20
Self-Diagnosis
→
1
→
2.0 °CA
94.2 °C
1
→
4.0 °CA
93.2 °C
Work step 2:
Erasing fault memory
K -
Enter function 05 Erasing fault memory and
confirm entry with key Q.
Note:
Readiness code is erased each time the fault
memory is erased.
If the ignition is switched off during Interrogat-
ing fault memory and Erasing Fault memory,
the fault memory is not erased.
-
→ Press.
Work step 3:
Switching off ignition
-
Wait at least 5 seconds with ignition OFF.
Note:
This point is important, because with certain di-
agnoses the slowing down of the control unit
must be ended. Otherwise readiness code can-
not be generated.
Work step 4:
Switching on ignition
-
Wait at least 10 seconds with ignition OFF.
Charge pressure sender is adapted with atmos-
pheric charge pressure sender.
Work step 5:
1st test of fuel supply and
other systems
-
Start engine.
-
Select function Reading measured value
block and display group 001.
K -
For 5 seconds increase the engine speed to
2500 rpm and then run engine at idling
speed.
Work step 6:
1st test of exhaust gas recir-
culation
K -
Increase engine speed to 1600 rpm up to
1700 rpm and maintain it for at least 10 sec-
onds in this range.
In this speed range, the exhaust gas recircula-
tion is active and the control difference is
checked. (Condition for readiness code to gen-
erate exhaust gas recirculation).
01
------------ 01-27 -------------