Skoda OCTAVIA 2004 Workshop Manual page 93

OCTAVIA
Edition 03.98
S00.5111.52.20
Fuel Formation / Fuel Injection
Note:
K Ensure the retaining claw is correctly positioned.
- Tighten the securing nut to 20 Nm.
- Once again, check the TDC marking at the
flywheel.
- Tighten the new bolts for attaching the injec-
tion pump sprocket to 20 Nm.
Note:
The bolts for attaching the sprocket must only
be used once as these are stretch bolts.
- Tighten the bolt for attaching the camshaft
sprocket to 45 Nm (counterhold with MP
1-216).
- Remove the locking pin 3359.
- Remove the adjusting straightedge MP 1-312
from the camshaft.
- Rotate the crankshaft two revolutions in di-
rection of rotation of engine until the crank-
shaft is again positioned at TDC of cylinder
1.
- Check whether the injection pump sprocket
can be locked with locking pin 3359.
If it is not possible to lock the injection pump
sprocket:
- Rotate the crankshaft sufficiently until the
holes for the locking pin are aligned and lock
the injection pump sprocket with locking pin
3359.
- Slacken the bolts attaching the injection
pump sprocket.
- Rotate crankshaft until the help marking on
the flywheel is aligned with the edge of the
adjusting device.
If it is possible to lock the injection pump
sprocket:
- Tighten the bolts attaching the injection pump
sprocket to 20 Nm + ¼ turn (90°).
- Remove locking pin 3359.
23
------------ ------------