Selections Available For A Unit In Direct Mode; Selections Available For A Host Unit In Switched Mode - ADTRAN Express 5200 User Manual

Selections Available for a Unit in Direct Mode

For D
specified. This information must be specified in both the local and
remote units. Voice data may be multiplexed with data on the same
DLCI.
Line 1 DLCI (L1 DLCI)
Local DLCI that Line 1 voice data is carried on.
Line 2 DLCI (L2 DLCI)
Local DLCI that Line 2 voice data is carried on.

Selections Available for a Host Unit in Switched Mode

This selection gives access to the remote extension table that is
maintained by the H
associated with the voice data on a remote Express 5200 and the
extension for the two voice ports connected to that DLCI. The
Express 5200 supports up to 20 DLCIs which yield a total of 40
voice ports. On the front panel,
keys are used to edit this table. The DLCI/Extension information is
communicated to the remote units over the network so configura-
tion is not required on the remote units.
Extension 1 (EXT 1)
Enter the extension for line 1 on a remote Express 5200.
Extension 2 (EXT 2)
Enter the extension for line 2 on a remote Express 5200.
DLCI
Local DLCI that carries E
Cascade Entry (CASCADE)
Set to Y
units, connect via a
Y
ES
host's DLCI field (described previously).
61202175L1-1
connections, the DLCI for voice traffic must be
IRECT
unit. The table consists of a local DLCI
OST
XTENSION
when cascading units from the host unit. To cascade
ES
port. Set the host unit's C
DTE
and enter the DLCI number connecting the two units into the
Express 5200 User Manual
Chapter 7. Voice Interface Configuration
, , , and
Next Previous Add
1 and 2 data.
ASCADE
Delete
E
to
NTRY
7-3